Caleffi S.p.A Approvals


#2401700

Range of T-type thermostatic mixing valves (chrome plated DZR brass). The 521928 model incorporates stainless steel strainers in the inlets and approved check valve cartridges, verified by test (suitable for backflow protection against Fluid Category 2). Maximum working pressure: 10.0 Bar. Temperature: 90°C

Section:
2010 Shower Valves
Section Subtitle:
Shower valve(s) with thermostatic temperature control
WRAS Approval Number:
2401700
Size:
See models.
Marking:
Caleffi logo, CR, H+C & MIX on body. Caleffi and product info on cap.
Installation Requirements:
R001 R040
Expiry date:
31/01/2029
Model:
521906 – 1 1/4” BSP male threaded connections, 521928 - 28mm Compression (For use with copper pipe EN1057).

Approval Holder:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company
Manufacturer:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company

Print This Approval


#2307337

Range of T-type thermostatic blending valves with chromium plated brass bodies. Temperature is controlled via a thermostatic cartridge. The inlets of all models except model 521308, 521324, 521314 and 521318 incorporate single check valve cartridges (verified by test - suitable for backflow protection against Fluid Category 2) and stainless-steel strainers. Compression fitting connection to be used with copper pipe EN1057 only. Maximum working pressure 10 bar. Maximum operating temperature 85°C except for models CA-100827 & CA-100828 both 60°C

Section:
2010 Shower Valves
Section Subtitle:
Shower valve(s) with thermostatic temperature control
WRAS Approval Number:
2307337
Size:
See models
Marking:
Caleffi logo, direction of flow, Date of Manufacture (WW/YY) & CR on Body
Installation Requirements:
R001 R010 R040
Expiry date:
31/07/2028
Model:
521308 1” Thermostatic Mixing Valve – Body Only 521324 ¾” Thermostatic Mixing Valve – Body Only 521314 ¾” Thermostatic Mixing Valve – Body Only 521318 1” Thermostatic Mixing Valve – Body Only 521303 ¾” T Pattern Thermostatic Mixing Valves 521304 ½” T Pattern Thermostatic Mixing Valves 521306 1” T Pattern Thermostatic Mixing Valves 521315 15mm T Pattern Thermostatic Mixing Valves 521315 LTC 15mm T Pattern Thermostatic Mixing Valves 521322 22mm T Pattern Thermostatic Mixing Valves 521322 LTC 22mm T Pattern Thermostatic Mixing Valves CA-100822 15mm T Pattern Thermostatic Mixing Valve Connector CA-100824 22mm T Pattern Thermostatic Mixing Valve Connector CA-100827 15mm MX Pattern Thermostatic Mixing Valve Connector CA-100828 22mm MX Pattern Thermostatic Mixing Valve Connector
Product Images

Approval Holder:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company
Manufacturer:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company

Print This Approval


#2403800

`354` range of distribution manifolds with DZR brass bodies and multiple (2, 3, 4 or 5) shut off valves for hot and cold water services, for use with copper tube to (manufactured to BS EN 1057). Maximum working pressure 10.0 bar. Maximum operating temperature 85°C.

Section:
1950 Manifolds
Section Subtitle:
Metal.
WRAS Approval Number:
2403800
Size:
See model
Marking:
Caleffi logo on body and operating member. CR on body.
Installation Requirements:
R001
Expiry date:
31/03/2029
Model:
354052 Manifold: ¾” BSP (F) x ¾” BSP (M) x ø23mm 2 connections. 354053 Manifold: ¾” BSP (F) x ¾” BSP (M) x ø23mm 3 connections. 354054 Manifold: ¾” BSP (F) x ¾” BSP (M) x ø23mm 4 connections. 354055 Manifold: ¾” BSP (F) x ¾” BSP (M) x ø23mm 5 connections. Models added September 2024: 354252 Manifold: ¾” BSP (F) x ¾” BSP (M) x ½” BSP (M) 2 connections. 354253 Manifold: ¾” BSP (F) x ¾” BSP (M) x ½” BSP (M) 3 connections. 354254 Manifold: ¾” BSP (F) x ¾” BSP (M) x ½” BSP (M) 4 connections. 354255 Manifold: ¾” BSP (F) x ¾” BSP (M) x ½” BSP (M) 5 connections.
Product Images

Approval Holder:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company
Manufacturer:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company

Print This Approval


#2309313

‘SATK 32’ range of indirect heat interface units providing instantaneous hot water. Domestic hot water is provided via a plate heat exchanger and this circuit incorporates a flow detector, stainless-steel filter and water hammer arrestor. The primary/space heating circuit incorporates a pressure relief valve set at 2.5 bar and an expansion vessel. Maximum working pressure of the domestic hot water circuit is 10.0 bar. Maximum working pressure of the primary circuit is 16.0 bar. Maximum working pressure of the space heating circuit is 2.5 bar. Maximum operating temperature 90°C.

Non-metallic materials and components comply with BS6920 at 85°C

Section:
1465 Heaters
Section Subtitle:
Combination boilers and Water Jacketed Tube heaters. Low volume water content. Heat retained in water heaters will cause expansion of water after closure of draw-off taps and valves. Provision for expansion of water must be made to accommodate excess pressure within the system. Particular care is required where check valves are positioned, or loose jumper valves are thought to be upstream of the heater.
WRAS Approval Number:
2309313
Size:
¾” BSP (M).
Marking:
Caleffi and Caleffi logo moulded on face of unit. Caleffi, Caleffi logo, model number and technical info on data plate inside unit.
Installation Requirements:
R001 R140 R360
Expiry date:
30/09/2028
Model:
SATK32103 - Wall-mounted Indirect Heat Interface Unit for Instantaneous domestic hot water production – DHW capacity 50kW. SATK32105 - Wall-mounted Indirect Heat Interface Unit for Instantaneous domestic hot water production – DHW capacity 60kW. SATK32107 - Wall-mounted Indirect Heat Interface Unit for Instantaneous domestic hot water production – DHW capacity 75kW.
Product Images

Approval Holder:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company
Manufacturer:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company

Print This Approval


#2309362

SATK Series 22 range of wall-mounted direct heat interface units providing heating and instantaneous hot water. The hot water is generated via a plate heat exchanger. Maximum working pressure of all water circuits (secondary hot water, primary and space heating) 10.0 bar. Maximum operating temperature 90°C.

Section:
1460 Heaters
Section Subtitle:
Supplied from storage only, gas, thermal storage.
WRAS Approval Number:
2309362
Size:
¾” BSP (M)
Marking:
Caleffi on casing. Model, pressure and other technical information on adhesive label inside casing.
Installation Requirements:
R001 R140 R360
Expiry date:
30/09/2028
Model:
SATK22303 - Wall-mounted Direct Heat Interface Unit for Instantaneous domestic hot water production – DHW capacity 50kW. SATK22305 - Wall-mounted direct Heat Interface Unit for Instantaneous domestic hot water production – DHW capacity 60kW. SATK22307 - Wall-mounted direct Heat Interface Unit for Instantaneous domestic hot water production – For low temperature primary circuit.
Product Images

Approval Holder:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company
Manufacturer:
Caleffi S.p.A
Company Name
Caleffi S.p.A
Address
Strada Regionale 229 n. 25 Fontaneto d'Agogna (NO)
Postcode
28010
Phone
+39 0322 8491
General Email
gary.perry@caleffi.com

View All Listings by this Company

Print This Approval



Back To Directory Sections

Page 9 of 14

We use cookies to give you the best possible experience with WRAS. Some are essential to provide website functions and ensure the website is secure. We also use cookies to help us understand how people use the site and to make improvements. Click "Accept All" to enable recommended settings or click "Manage cookies" to adjust your settings. For more details, see our Cookie Policy.