'JM-EP01'. Black coloured, compression moulded EPDM material. Shore hardness 75. Tested in-radius size 1.0mm. For use with water up to 85°C.

Section:

5365 Rubbers

Section Subtitle:

Ethylene Propylene Diene Monomer (EPDM) - material only. Components made from materials listed in this section may be required to be submitted for audit tests.

WRAS Approval Number:

2309510

Expiry date:

30/09/2028

Manufacturer:

Wuhu Jinmao Environmental Science & Technology Co. Ltd.

Company Name

Wuhu Jinmao Environmental Science & Technology Co. Ltd.

Address

The Industrial Zone in Suncun Town, Fanchang County, Anhui Province

View All Listings by this Company

'JM 9-2910'. Factory applied, blue coloured epoxy powder coating. Apply as per manufacturer's instructions 'edition no.1', issue date 2012-8-5. Cure for 15 minutes@180°C. For use with water up to 85°C. This material is only approved for the curing conditions that appear on the approval. If the cure conditions are varied from those specified on the approval then the material is not covered by the scope of the approval.

Section:

5030 Coatings, Paints & Linings

Section Subtitle:

Factory applied pipe & fittings coatings.

WRAS Approval Number:

2309512

Expiry date:

30/09/2028

Manufacturer:

Wuhu Jinmao Environmental Science & Technology Co. Ltd.

Company Name

Wuhu Jinmao Environmental Science & Technology Co. Ltd.

Address

The Industrial Zone in Suncun Town, Fanchang County, Anhui Province

View All Listings by this Company