Section Code 5297 : Material only. Components made from materials listed in this section may be required to be submitted for audit tests.
Back To Directory Sections'Estane 58197 Nat 22'. Natural (transparent, colourless), injection moulded thermoplastic polyurethane material. For use with water up to 85°C.
‘Estane® Grades 58887 Nat 036, 58315 Nat 035, 58315 Nat 033, 58887 Nat 052, 58300 Nat 033, 58300 Nat 036, 58887 Nat 029, 58315 Nat 055, 58887 Nat 038 & 58887 Nat 055’. Natural (transparent, colourless), injection moulded TPU materials. For use with water up to 23°C.
‘Hypore 25ppi 90’. Cream coloured, polyurethane foam manufactured by chemical foaming. For use with water up to 23°C.
'Versilon™ C-544-A I.B'. Triple layered, extruded tube consisting of a transparent (clear) polyurethane inner layer, white coloured polyester middle layer & transparent (clear) polyurethane outer layer. For use with water up to 65°C.
'N-PU.95R'. Red coloured, injection moulded PUR material. For use with water up to 23°C.
'Tecoflex TU40 GR30 GR128 HS D6 QF'. Light grey coloured, injection moulded TPU material. For use with water up to 23°C.
'Wevonat 1000 & Wevopur 2082'. Factory applied, two-component polyurethane potting compound which is cream in colour once mixed. Mix and apply 'Wevonat 1000 & Wevopur 2082' as per Wevo Technical Datasheet 'pur2082_nat1000_engl version 12/18'. Cure for 8 hours@80°C. For use with water up to 23°C. This material is only approved for the curing conditions that appear on the approval. If the cure conditions are varied from those specified on the approval then the material is not covered by the scope of the approval.
`USW-85`. Black coloured, injection moulded TPU material. For use with water up to 23°C.
'USW-95-A Black'. Black coloured, injection moulded TPU material. For use with water up to 23°C.
'4TECH 9T22130 HW-A AGY'. Light grey coloured, injection moulded TPU material. For use with water up to 23°C.
‘DU-51/DU-6104 Polyurethane’, factory applied, colourless (transparent), two-component polyurethane adhesive. Mix ‘DU-51’ and ‘DU-6104’ in a weight ratio of 53:47 and apply as per manufacturer’s instructions. Cure for 7 days@25°C. For use with water up to 23°C. This material is only approved for the mixing and curing conditions that appear on the approval. If the mix and/or cure conditions are varied from those specified on the approval then the material is not covered by the scope of the approval.
'(UREFLEX) TM390'. Off-white coloured, injection moulded PUR material manufactured by casting. For use with water up to 23°C.
Page of