'Ultrason® P 3010 MR grau 30373'. Grey coloured, injection moulded PPSU material. For use with water up to 85°C.

Section:

5256 Polyphenylsulfone

Expiry date:

30/04/2030

Approval Holder:

BASF SE

Company Name

BASF SE

Address

Carl-Bosch-Str. 38, 67056 Ludwigshafen

Country

Germany

View All Listings by this Company

‘+GF+'. Green coloured, extruded PPR pipe. For use with water up to 85°C.

Section:

5260 Polypropylene

Section Subtitle:

Components.

WRAS Approval Number:

250455032

Expiry date:

30/04/2030

Approval Holder:

GF Corys Piping Factory - L.L.C. - O.P.C.

Company Name

GF Corys Piping Factory - L.L.C. - O.P.C.

Address

Mussafah South, ICAD III, Plot 159SR47, PO Box 4894, Abu Dhabi

Country

United Arab Emirates

View All Listings by this Company

'Lubricomp CG006-NA1G003 Black'. Black coloured, injection moulded polystyrene material. For use with water up to 85°C.

Section:

5270 Polystyrene

Section Subtitle:

Material only. Components made from materials listed in this section may be required to be submitted for audit tests.

WRAS Approval Number:

250455027

Expiry date:

30/04/2030

Approval Holder:

SHPP B.V.

Company Name

SHPP B.V.

Address

Plasticslaan 1, 4612PX, Bergen Op Zoom

Country

Netherlands

View All Listings by this Company

'PRO V200'. Site applied, two-part (supplied with internal mixing nozzle so no manual mixing required), brown coloured chemical anchor resin. Apply as per manufacturer's instructions 'Version 7', dated '18/05/2022'. Cure for 4 days@5°C. For use with water up to 23°C. For use only as a resin anchor having been tested at a reduced surface area to volume ratio of 1,000mm² per 1 litre of water. This material is only approved for the mixing and curing conditions that appear on the approval. If the mix and cure conditions are varied from those specified on the approval then the material is not covered by the scope of the approval.

Section:

5311 Resin Anchors

Expiry date:

30/11/2028

Approval Holder:

Proventure Solutions Ltd.

Company Name

Proventure Solutions Ltd.

Address

Lakeside Barn, Snipe Hall Farm, Wanes Blades Road, Ormskirk

Postcode

L40 4BN

View All Listings by this Company

'ASIIR60WRC'. Black coloured, mould pressed isobutylene isoprene rubber. Shore hardness 65. Tested in-radius size 1.0mm. For use with water up to 85°C.

Section:

5330 Rubbers

Section Subtitle:

Butyl - material only. Components made from materials listed in this section may be required to be submitted for audit tests.

WRAS Approval Number:

240455067

Expiry date:

30/04/2029

Approval Holder:

Ashton Seals Limited

Company Name

Ashton Seals Limited

Postcode

S73 0YP

View All Listings by this Company