Range of hand wash and dryer units The flow is controlled by a solenoid valve activated via an infra-red sensor. The products are supplied with a non-verifiable double check valve assembly (suitable for backflow protection against Fluid category 3) for installation on the inlet. The double check valve assembly also incorporates a drain port, (located in between the cartridges), and an integral spherical valve. Maximum working pressure 10.0 bar. Maximum operating temperature 50ºC.

Section:

1530 Miscellaneous Fittings

WRAS Approval Number:

2107098

Expiry date:

31/07/2026

Note:

R008 applies to the solenoid valves and stainless steel braided PEX lined flexible hose assemblies.

Size:

15mm compression

Marking:

Wallgate on face cover. Wallgate, model, serial number, date of manufacture (DD/MM/YY) and other product info on label on control panel.

Installation Requirements:

R001 R008 R040 R570

Model:

Thrii-SS (Solid Surface fascia), Thrii-DIS-SS (Disabled design, Solid Surface fascia), Thrii-ST (Stainless Steel fascia), Thrii-CW-SS (Cold water only, Solid Surface fascia - instantaneous water heater removed), Thrii-CW-ST (Cold water only, Stainless Steel fascia - instantaneous water heater removed), Thrii-DIS-CW-SS (Disabled design, Cold water only, Solid Surface fascia - instantaneous water heater removed), Thrii-ST-RA (Stainless Steel fascia – Rear Access), Thrii-SS-RA (Solid Surface fascia – Rear Access), Thrii-Marine.

Manufacturer:

Wallgate Limited

Company Name

Wallgate Limited

Address

Crow Lane Wilton Salisbury Wiltshire

Postcode

SP2 0HB

Phone

Tel: 01722 744594 Fax: 01722 742096

View All Listings by this Company

Single hole, single outlet deck mounted (fixed) combination tap assembly with soap dispenser and hand dryer appliances operated via an infra-red sensor. This product incorporates a solenoid valve and plastic flow restrictor. Maximum working pressure 10.0 bar. Maximum operating temperature 50°C.

Section:

0450 Combination Tap Assemblies

Section Subtitle:

Single hole, metal single outlet, fixed. Taps used in high risk installations, such as kitchen sinks, are considered to be a fluid category 5 risk. Backflow protection is usually provided in the form of an AUK3 tap gap. Where an AUK3 tap gap cannot be maintained, for example where the tap gap is compromised as a result of: • the tap being lowered in any way; • adjustment to the spout which reduces the distance between the tap outlet and spillover level of the sink; • or the operation of a pull out hose attachment; alternative fluid category 5 backflow protection is required.

WRAS Approval Number:

2109363

Expiry date:

30/09/2026

Note:

This product may not comply with the requirements of regulation 4(1)(b). Consult your local water undertaker prior to installation.

Size:

½” BSP (M)

Marking:

Wallgate logo (W) on fascia of tap.

Installation Requirements:

R001 R006 R009 R570

Model:

THRII-TAP+D ( Deck mounted)

Manufacturer:

Wallgate Limited

Company Name

Wallgate Limited

Address

Crow Lane Wilton Salisbury Wiltshire

Postcode

SP2 0HB

Phone

Tel: 01722 744594 Fax: 01722 742096

View All Listings by this Company