Range of gas fired instantaneous condensing domestic hot water heaters with integral storage tank. Having a stainless-steel coil and built in circulating pump. Maximum working pressure 11.0 bar. Maximum operating temperature 80°C

Section:

1465 Heaters

Section Subtitle:

Combination boilers and Water Jacketed Tube heaters. Low volume water content. Heat retained in water heaters will cause expansion of water after closure of draw-off taps and valves. Provision for expansion of water must be made to accommodate excess pressure within the system. Particular care is required where check valves are positioned, or loose jumper valves are thought to be upstream of the heater.

WRAS Approval Number:

1907322

Expiry date:

31/07/2024

Size:

1½” BSP (M)

Marking:

Cosmogas on front casing. Cosmogas, production date (YYYY) and other technical information on adhesive label on side of body

Installation Requirements:

R001 R140

Model:

Aguaplus 60, 70, 100, 115, 140

Manufacturer:

Cosmogas Srl

Company Name

Cosmogas Srl

Address

View All Listings by this Company

Aguadens range of direct fired, gas condensing water heaters with stainless steel tubes and EPDM ‘O’-rings. The products incorporate a drain tap. Maximum operating pressure 11.0 bar. Maximum operating temperature 60˚C.

Section:

1400 Heaters

Section Subtitle:

Gas fired, closed outlet. Heat retained in water heaters may cause expansion of water after closure of draw-off taps and valves. Provision for expansion of water must be made to prevent excess pressure within the system.

WRAS Approval Number:

1909361

Expiry date:

30/09/2024

Size:

60T, 70T, 100T, 115T, 140T models: 2” NPT (M). 180T, 210T, 280T models: 2½” NPT (M).

Marking:

Cosomgas on front of body

Installation Requirements:

R001 R140 R511

Model:

Aguadens 60T, 70T, 100T, 115T, 140T, 180T, 210T & 280T.

Manufacturer:

Cosmogas Srl

Company Name

Cosmogas Srl

Address

View All Listings by this Company

Range of wall mounted combination boilers providing domestic hot water via a heat exchanger and pressurised central heating system.Incorporating a pressure relief valve set at 3.0 bar and an expansion vessel. Maximum working pressure of 2.5 bar (primary) & 7.0 bar (secondary). Cold supply only. Maximum operating temperature 60°C.

Section:

1465 Heaters

Section Subtitle:

Combination boilers and Water Jacketed Tube heaters. Low volume water content. Heat retained in water heaters will cause expansion of water after closure of draw-off taps and valves. Provision for expansion of water must be made to accommodate excess pressure within the system. Particular care is required where check valves are positioned, or loose jumper valves are thought to be upstream of the heater.

WRAS Approval Number:

1910339

Expiry date:

31/10/2024

Size:

Secondary – inlet ½” BSP(M) & 15mm copper tail outlet. Primary – 22mm copper tail.

Marking:

Cosmogas on front of boiler.

Installation Requirements:

R001 R360

Proviso:

Not supplied with a temporary filling loop. A filling loop must be installed with the appropriate backflow prevention device in accordance with clause G24.2, Guidance to the Water Supply (Water Fittings) Regulations 1999.

Model:

Mydens 34P, Q30P & Mydens 24P

Manufacturer:

Cosmogas Srl

Company Name

Cosmogas Srl

Address

View All Listings by this Company