Range of T-type thermostatic mixing valves (brushed nickel plated DZR brass bodies). Temperature is pre-set under a fixed cap. Both inlet tails incorporate single check valve cartridges (suitable for backflow protection against Fluid Category 2) and stainless steel strainers. HEAT110615, 110616, 110617 & 110625 models include isolation valves on the inlets. Maximum working pressure 6.0 bar. Maximum operating temperature 85°C.
T-handle, in-line spherical valve with a nickel plated DZR brass body and chromium plated brass ball, incorporating PTFE seats and nitrile ‘O’-rings. Maximum working pressure 25.0 bar. Maximum operating temperature 85°C.
T type thermostatic blending valve with DZR brushed chrome brass body and EPDM O-rings. Maximum working pressure 6.0 bar. Maximum operating temperature 85°C.
Tenant valve assemblies with a DZR brass body consisting of water meter manifold, servicing valve and a pressure reducing valve (adjustable between 1.0 and 5,0 bar). The inlet incorporates two approved check valve cartridges, verified by test (suitable for backflow protection against Fluid Category 3). Push fit connections are only for use with either copper pipe, PEX pipe manufactured to BS7291 class S or PB pipe manufactured to BS7291/2 class S. Maximum working pressure of push fit connections (and supply pressure to pressure reducing valve) = 12.0 bar with PEX & PB pipe and 16.0 bar with copper pipe. Maximum working pressure of BSP threaded connections (and supply pressure to pressure reducing valve) = 16.0 bar Maximum operating temperature of all 80°C. Above ground use only.
Protecto YC Y-strainer with brass body incorporating a stainless-steel mesh filter and EPDM ‘O’-ring seals. Maximum working pressure 10.0 bar. Maximum operating temperature 85°C.
Range of in-line non-verifiable single check valve assemblies consisting of a spring loaded resilient trim single check valve cartridge housed within a DZR brass body. Maximum working pressure 16.0 bar. Maximum operating temperature 85°C.
Range of in-line screwdriver and lever operated spherical valves with chromium plated brass bodies and balls, EPDM seals and ‘sharkbite’ push fit end connections. Maximum working pressure 10.0 Bar. Maximum operating temperature 90°C.
Reliance range of in line adjustable pressure reducing valves with DZR brass bodies and EPDM diaphragm. The outlet pressures can be set in the range 1.5 – 5.5 bar via a screw cap. To be used with copper, polybutylene (manufactured to BS7291-2) and PEX (manufactured to BS7291-3) pipes. Maximum inlet supply pressure 16.0 bar. Cold water use only.
Range of adjustable in-line pressure reducing valves with bronze bodies and manually operated pressure reducing mechanism. Outlet pressure adjustable between 1.5 to 6.0 bar. Maximum supply pressure 16.0 bar. Maximum operating temperature 60°C.
Combined temperature and pressure relief valve incorporating a gunmetal body and manually operated lever-type easing gear. Factory set at 7.0 bar. Maximum operating temperature 95°C.
Page 1 of 2