Range of Talbot pushfit fittings with polypropylene or acetal bodies and EPDM O-Rings for use with MDPE pipe (manufactured to EN 12201). Supplied with pipe inserts. For above and below ground use. Maximum working pressure 16.0 bar. Cold water use only.
Range of screw down stop valves with gunmetal bodies and nitrile seat washer. The Ebco-S range is suitable for above ground use only as they are of the non-manipulative type. All other ranges are for above and below ground use. Maximum working pressure 16.0 bar. Cold water use only.
Above ground water meter box for installation in to a wall cavity, the box incorporates a concentric water meter manifold, quarter turn stop valve and a non-return valve (not suitable for backflow protection). Maximum working pressure 16.0 bar. Cold water use only.
‘EBCO’ range of water meter boxes with plastic or gunmetal manifolds. The inlets to manifolds incorporate a quarter turn isolation valve. The products also incorporate an approved check valve cartridge; however, the complete assembly has not been fully tested to demonstrate that it provides backflow protection - and is not intended for this purpose. Below ground use. Maximum working pressure 12.5 bar. Cold water use only.
Range of water meter manifolds with plastic bodies incorporating a drain off valve. Inlets incorporate a plastic strainer. Products also incorporates an approved check valve cartridge however, the complete product has not been fully tested to demonstrate it provides backflow protection. Cold water use only. Maximum working pressure 16.0 bar.
`Talbot, Atplas, Ebco & S Booth` ranges of injection moulded, acetal fittings. Talbot fittings available in: F10 black, F20 blue, F20 black, F10 natural, F20 natural & F10 & F20 black. Atplas fittings available in: F10 natural, F20 natural, F10 & F20 natural & F20 red. Ebco fittings available in: F10 natural, F20 natural, F20 blue, F20 red, F20 yellow & F20 black. S Booth fittings available in: F20 natural. For use with water up to 60°C.
Talbot range of self tapping ferrule straps with plastic bodies and a nitrile rubber seal. The product incorporates either a ¾” BSP (M) connection or a 25mm or 32mm push fit connection on the outlet from the cutting arm. For below ground use only. Maximum working pressure 16.0 bar. Cold water use only.
Range of water meter manifolds with plastic bodies. The inlets incorporate a spherical valve and a non-return valve (not suitable for back flow protection). Model MD1010101BM is for use with Irish Heavy gauge pipe manufactured to 15134/1977. All other models are for use with blue MDPE pipe manufactured to EN12201. Maximum working pressure 12.5 bar. Cold water use only.
Range of water meter manifolds with a plastic body and a spherical valve at the inlet. Models MB2012525DM & MB2010303DM incorporates two single check valve cartridges, all other models incorporate one single check valve however, the complete product has not been fully tested to demonstrate it provides backflow protection Model MB201010BM is for use with Irish Heavy gauge pipe manufactured to 15134/1977. All other models are for use with blue MDPE pipe manufactured to EN12201. Maximum working pressure 12.5 bar. Cold water use only.
Range of meter boxes incorporating a plastic manifold arrangement consisting of a stop valve with non-rising spindle , check valve (however the complete assembly has not been tested to demonstrate it provides adequate backflow) and concentric meter port. Some models incorporate a drain off or blacking plug. Connections can be compression or push fit (see model). For use with PE8-0 pipe to BS EN 12201 and copper to EN 1057. Maximum working pressure 16.0 bar. Cold water use only.
Page 1 of 2