Range of flow restrictors with plastic aerators. The inlet incorporates a stainless steel strainer. The outlet has a switch mode which changes the flow form a normal flow to a spray flow. Maximum operating temperature 60°C.

• Section: 0435 Combination Tap Assemblies - Components
• Section Subtitle: Aerators, Flow Straighteners, Flow Regulators and Restrictors.
• WRAS Approval Number: 1804021
• Expiry date: 30/04/2023
• Size: M24 Adaptor
• Marking: AIR FORCE (brand name of Orfesa S.A) on body
• Installation Requirements R001 R040
• Model
  RC-145A.0.1631 Swivel Shower Flow restrictor 8 L/min. RC-145A.0.00 Swivel Shower Flow restrictor.
• Manufacturer: Orfesa S.A.
  Company Name

  Orfesa S.A.

  Address

  C/Feixa Llarga, 54 08907 L'Hospitalet de Llobregat Barcelona
  View All Listings by this Company

Shower adaptor (chromium plated brass) with a built in plastic flow restrictor. Maximum operating temperature 60ºC.

• Section: 0435 Combination Tap Assemblies - Components
• Section Subtitle: Aerators, Flow Straighteners, Flow Regulators and Restrictors.
• WRAS Approval Number: 1807045
• Expiry date: 31/07/2023
• Note: Open outlet use only.
• Size: ½” BSP (F)
• Marking: Orfesa logo (the letters ‘or’ located above ~) on body
• Installation Requirements R001 R040
• Model
  ES-221.7.00
• Factor: Orfesa S.A.
  Company Name

  Orfesa S.A.

  Address

  C/Feixa Llarga, 54 08907 L'Hospitalet de Llobregat Barcelona
  View All Listings by this Company

Two-hole, single outlet combination tap assemblies (chromium plated brass) incorporating a ceramic cartridge headwork with a single lever operating member. The outlet is a pull-out spray type (chromium plated plastic) and incorporates a plastic aerator. Maximum working pressure 5.0 bar. Maximum operating temperature 60°C.

• Section: 0445 Combination Tap Assemblies
• Section Subtitle: Pullout spray. Taps used in high risk installations, such as kitchen sinks, are considered to be a fluid category 5 risk. Backflow protection is usually provided in the form of an AUK3 tap gap. Where an AUK3 tap gap cannot be maintained, for example where the tap gap is compromised as a result of: • the tap being lowered in any way; • adjustment to the spout which reduces the distance between the tap outlet and spillover level of the sink; • or the operation of a pull out hose attachment, alternative fluid category 5 backflow protection is required.
• WRAS Approval Number: 1910033
• Expiry date: 31/10/2024
• Size: Stainless steel braided EDPM lined flexible hose assemblies incorporating 15mm compression end connections.
• Marking: Orfesa logo on rear of body.
• Installation Requirements R001 R090
• Model
  PL-327 & PL-32
• Manufacturer: Orfesa S.A.
  Company Name

  Orfesa S.A.

  Address

  C/Feixa Llarga, 54 08907 L'Hospitalet de Llobregat Barcelona
  View All Listings by this Company