Range of single check valve assemblies with DZR brass Tee shaped bodies. Maximum working pressure 10.0 Bar. Maximum operating temperature 85°C
Range of below ground hose union taps within a chamber incorporating a brass spherical valves, hose connector and MDPE couplings. Maximum working pressure 10.0 bar. Maximum operating temperature 100°C
‘Boost a Break’ range of break tank and booster sets incorporating a solenoid valve controlling the flow, polypropylene tank and pump having a single check valve cartridge at the inlet (however the complete assembly has not been tested to demonstrate it provides adequate backflow protection). The pump sets have various flow rates and pressures depending in installation requirements. The tank incorporates a type `AB` airgap (verified by test - suitable for backflow protection against fluid category 5). Maximum working pressure 10.0 bar. Cold water use only.
In-wall concealed, manually accessible and operated hose connector incorporating a brass body, quarter turn ceramic disc headwork and operated by removable key. Maximum working pressure 10.0 bar. Maximum operating temperature 85°C.
Pent-A-Boost domestic break tank and booster set incorporating a single or dual pump stage pump set assembly and break cistern (incorporating an AG air gap arrangement). Inlet level sensors control the water supply via solenoid valves with inline strainers fitted (see manufacturers data sheet for optional arrangements). The unit also incorporates an expansion vessel. Flow from the break tank is via a single check valve suitable for fluid category 2 to a booster pump arrangement (see manufacturers data sheet for optional arrangements). Maximum working pressure 10 bar. Cold water use only.
Standpipe assembly break tank with a Type ‘AB’ air gap (verified by test – suitable for backflow protection against fluid category 5) mounted to the top of the standpipe body. The tank is filled via a compact float valve and has two screened weir slots. Water is then supplied by gravity from the break tank to the hose outlet below. Flow is activated via a spherical valve located behind a lockable panel. In addition to the isolation valve, the product incorporates a single check valve assembly (suitable for backflow protection against Fluid Category 2) prior to the spherical valve and an in-line ‘Y’ pattern strainer after it. The spherical valve includes a drain plug to allow for draining. Insulation is provided up to the drain point. Maximum working pressure 10.0 bar. Cold water use only.
Page 2 of 2